Linksys is the name which is world famous for its internet service. Many of the internet users like to be a part of the Linksys family. But, as the login process is unknown to them, they need to call an expert for this. But by going through this article you will learn the total process of Linksys router login and setup. And after that, you can do this without any other’s help. So, let us now proceed for the steps of Linksys login.
The process of Linksys login is very simple, you can do this on your own, only by going through this learning steps of this article.
To begin this process, at first, you need to set up the router properly. Join the router with the computing device using an ethernet cable. And then, ensure that the router is plugged into the power source and the switch is active. If these basics are OK, then proceed to these further Linksys login process.
The next step is to check the IP address of your Linksys router. And to do this at first, open the Control Panel window. Press the Windows key and the letter R at the same time, this will open the Run command bar at the left-hand side of your screen. Then, using the keyboard type cmd on it and hit on the Enter button. On doing this the Command window will get pop-ups. Type “ipconfig” on it and tap on the Enter button to execute. After, doing this, now search for the “Default Gateway” section from this Command Prompt window. The number which is beside to the Default Gateway section is the IP number of your router. Remember it or write it somewhere else.
After, arranging all these above needs, go for this step to open the login page of the Linksys router. At first, open a browser of your system. And, at the address bar of the browser type the IP address (which you get by following this above step), then hit on the Enter button. On doing this, the login page of the Linksys router will get open.
Now, as you get into the login page of the Netgear router, you need to fill up all the sections on it. Enter the username and password which is set for your router. Use the default username and password, if you have never changed these, either you need to enter the changing details which you have made. After, entering the proper username and password click on Login. And that’s all for the Linksys login process.
If you are facing any difficulty to use your Linksys router then, these above are the steps, which you need to follow. But in some cases, it is seen that many of the users forgot their username and password, which they set for their Linksys router. And this results in a problem to continue with the Linksys login process. If this is the case, then no worries. Just reset your router to reuse the Login page. And the process for these is in this below section.
Note: In the default case the password to get login to the Linksys router is admin and you need to keep the username space blank.
This is basically a troubleshooting method if you are facing any issue in using the Linksys router, then go for it. The process of doing this is very simple, and are explained in these below lines.
After, resetting your Linksys router then use the default username and password to follow the above Linksys login process.
To start this process, at first, connect the router with your computer device with the help of an ethernet cable. After that, enable the power switch of your router. Then, locate the Reset button from your router’s body. Take a thin pin, which can be able to get insert into the Reset hole. By using the pin or a paper clip, press and hold the reset button of your router for 12-30 seconds, depending upon your router model, until the power light blink. After releasing the Reset button, wait till all the blinking lights get stable. Then, reboot your router to complete the resetting process.
Hope, now you can be able to start with the Linksys login process using the default username and password.