Most of the users do not know the procedure of the Epson 1400 printer setup. However, the configuration process is not much complicated. You only need is a proper guideline. The booklet provided by the Epson while purchasing the printer is not sufficient for some people to understand its procedures. Furthermore, the language used in this booklet is quite difficult to understand. Hence, stay on this article, as this will help you to set up the Epson 1400 printer with some easy steps which you will easily understand.
Know Epson 1400 Printer Setup Most Easily
In the undermentioned section, we have mentioned the easiest way for Epson 1400 Printer setup. Therefore, check them out:
A Step-by-Step Process for Epson 1400 Printer Setup
Follow the step-by-step processes in order to set up the Epson printer.
Step 1
At first, remove all the tapes and the sheets as well. But before that, you should check whether everything is there as per described on the back of the printer packet. It is recommended that do not open the ink cartridges until you are ready for the installation process.
Step 2
After that, plug the power cable with the power source and press the power button of the printer. Then you should install the ink cartridges.
Step 3
To do that, lift up the printer cover and pen the cartridges cover from the printer. Then, unpack the ink cartridges. After that, remove the yellow tape from each ink cartridges. But, do not remove any other seals from the cartridges.
Step 4
Then, you need to insert the cartridges in the holder for each color gently. Next, press the cartridges softly down until they click.
Step 5
Here, close the ink cartridges cover and press it down until it clicks. Next, you should close the printer cover and then press the ink button to charge the ink. The minimum time takes to charge the ink is about three minutes. When you install the ink cartridges for the first time, the printer uses some ink to charge the printing system.
Step 6
The next step is to load the paper. To load the paper, first, open the paper support and pull up its extensions. After that, open the output tray and pull out its extension as well.
Step 7
Then, press in the release button and then slide the edge guide to the left. After that, load the paper against the right edge guide and behind the tab. It is recommended that always load the paper form its short edge first, do not load paper from the sideways.
Step 8
Next, hit the release button and slide the left edge guide over.
After the orientation is successful, you need to install the printer driver on your computer. You can install the printer driver using the CD or you can download the driver from the developer’s website.
Install Software
Hence, you will get the driver setup CD when you purchase the printer. But while installing the printer software you need to ensure that the printer does not connect with the computer. Also, disconnect all the USB cable, otherwise you cannot able to install the software. Once you have done that, go through the understated methods:
- Firstly, insert the software CD. An autoplay window will pop up then click Run Epsetup.exe option. After that, click the Continue at the user account control screen.
- Then, click Install option and follow the on-screen instructions to proceed further. It will take time to install the software.
- Press Next option 2 times. When a message will pop up on your screen which says connect the USB cable. Then use any open USB port on your computer. After that, you need to ensure that the printer is turned on.
- After that, follow the on-screen instructions to install the rest of the software and then register your Epson printer.
- When the process gets completed then remove the installation CD.
Now your printer is ready to print. Try to print a page and check whether the setup process is successful or not.
On the whole, performing the above steps will help you to set up the Epson printer with ease. Hence, follow this user guide and enroute the new journey with the Epson 1400 printer.
