192.168.1.250 is a private IP address that is utilized to access network devices. Mostly, this IP address is used with the Wi-Fi extenders, routers, and modems. This IP address can be described as the standard protocol RFC 1918. As an example, the IP address 192.168.1.250 is used as the default IP address of the Netgear Wi-Fi Extender.
You can even configure and setup the IP address 192.168.1.250 with the help of the mywifiext.net address. Since, it is utilized with a private network, the transmission lines are highly stable as well as you can’t connect to the internet directly. Moreover, you always need an IP address while logging into the router so that you will be able to configure the settings as per your requirements.
To log into the router, you can perform the steps as follows:
First of all, connect the router with the RJ45 cable and check if the network has started to work. Afterward, open your favored web browser and then type the IP address 192.168.1.250 in the address bar. Next, press the Enter key from the keyboard to continue.
Once you hit the Enter key, it will navigate you to the login window where you will get the options to provide the password and username. If you have changed the default password and username of the device previously, then be ready with the changed password and username. Check the password and username that are used the most:
Note: This combination of password and username is found to be accurate in the 90% cases.
Find the wireless settings under the Router Settings window. Now, be careful about the settings that you are going to change.
Here, you will get an option to set the network name or SSID, internet connection type, security settings, etc. Furthermore, if you want to change the router connection, you can also do that from here.
There are some tabs like System Settings, Firewall, Wireless Settings, Status under the Router Settings window. There are also several options such as Bandwidth, IP address, and even the Transmission rate. Hence, it’s always better to change the default login credential of the device.
You need to consider the below things while changing the default password and username of the device.
The Service Set Identifier or SSID is the name of the network that you can see when you open the network tab. Most of the time, SSID is the name of the router/modem manufacturer.
So, if you are using the default password and username of the device, then it will be easy for someone to guess the login credentials. Hence, it is essential to change the network name of the device.
Example of Network Name: Amazing_Internet, B9n6, Turn_web
Important Tips:
While changing the network name, consider the below points:
After applying the above steps, change the settings of the device. To do this, first, navigate to the Wireless Settings tab under the Router Settings window. Afterward, go to the ‘Encryption Settings’ section. Then, choose the ‘WPA2-PSK’ option from the list. It is the most accurate encryption standard for the router right now. It will then make sure that the device is running in its extreme optimum level.
No, the Netgear Nighthawk doesn’t support 5 GHz. It only supports a maximum of 2.4 GHz speed.
Using the IP address 192.168.1.250, you can log into the Netgear Nighthawk. Afterward, you have to enter the default login credentials.
To perform a reset of the Netgear Nighthawk, first, take a sharp-pointed object like a pin, paper clip. Then, press the Reset button of the device using that and hold it for a minimum of 8-12 seconds. Afterward, provide the default login credentials on the login page.